3Com 5500G-EI - Info-Center Channel Name

Log Commands 461
Parameter
size: Configure the size of buffer.
buffersize : Size of buffer (number of messages which can be kept); By default,
the size of the buffer is 256.
Description
Using display trapbuffer command, you can view the attribute of trapbuffer
and the information recorded in trapbuffer.
For the related commands, see info-center enable, info-center loghost,
info-center logbuffer
, info-center console channel, info-center
monitor channel.
Example
Show the system trapbuffer attribute and the log information in trapbuffer.
<SW5500>display trapbuffer
Trapping Buffer Configuration and contents:
enabled
allowed max buffer size : 1024
actual buffer size : 256
channel number : 3 , channel name : trapbuffer
dropped messages : 0
overwrote messages : 0
current messages : 6
Dec 31 14:01:25 2004 Quidway DEV/2/LOAD FINISHED:
Trap 1.3.6.1.4.1.2011.2.23.1.12.1.20: frameIndex is 0, slotIndex
0.4
Dec 31 14:01:33 2004 Quidway DEV/2/BOARD STATE CHANGE TO NORMAL:
Trap 1.3.6.1.4.1.2011.2.23.1.12.1.11: frameIndex is 0, slotIndex
0.2
Dec 31 14:01:40 2004 Quidway DEV/2/BOARD STATE CHANGE TO NORMAL:
Trap 1.3.6.1.4.1.2011.2.23.1.12.1.11: frameIndex is 0, slotIndex 0.
….
info-center channel
name
Syntax
info-center channel channel-number name channel-name
undo info-center channel channel-number
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specify the channel name with a character string not exceeding
30 characters, excluding "-", "/" or "\".