Ethernet Port Configuration Commands 67
speed Syntax
For a 100 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | auto }
For a 1000 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | 1000 | auto }
For a 10000 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | 1000 | 10000 | auto }
The undo form of this command is:
undo speed
View
Ethernet Port View
Parameter
10: Enter to set the port speed to 10 Mbps.
100: Enter to set the port speed to 100 Mbps.
1000: Enter to set the port speed to 1000 Mbps.
10000:Enter to set the port speed to 10000 Mbps.
auto: Enter to set the port speed to auto-negotiation.
Description
Use the speed command to configure the port speed. Use the undo speed
command to restore the default speed. By default, the speed is
auto.
Related command: duplex.
Example
To configure the port speed of port Ethernet1/0/1 to 10 Mbps, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]speed 1000
unicast-suppression Syntax
unicast-suppression {
ratio
| pps
pps
}
undo unicast-suppression
View
Ethernet Port View
To Next Page
Loading...
