Log Commands 471
buffersize:
Size of trap buffer (numbers of messages).
channel: Configure the channel to output information to trap buffer.
channel-number:
Channel number, ranging from 0 to 9, that is, the system has
ten channels.
channel-name:
Specify the channel name.
Description
Use the info-center trapbuffer command to output information to the trap
buffer. Use the
undo info-center trapbuffer command to cancel output
information to trap buffer.
By default, output information is transmitted to trap buffer and size of trap buffer
is 256.
This command takes effect only after the system logging is enabled.
Related commands: info-center enable, display info-center.
Example
Send information to the trap buffer and sets the size of buffer as 30.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center trapbuffer size 30
[SW5500]
reset logbuffer Syntax
reset logbuffer
View
User view
Parameter
None
Description
Use the reset logbuffer command to clear information in log buffer.
Example
Clear information in log buffer.
<SW5500>reset logbuffer
reset trapbuffer Syntax
reset trapbuffer
View
User view
To Next Page
Loading...
