186 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
View
All views
Parameter
process-id
Enter the process ID of OSPF, ranging from 1 to 65535. The
command is applied to all current OSPF processes if you do not specify a process
ID.
Description
Use the display ospf abr-asbr command to view information about the Area
Border Router (ABR) and Autonomous System Border Router (ASBR) of OSPF.
Example
To display information on the ABR and ASBR of OSPF, enter the following:
<SW5500>display ospf abr-asbr
OSPF Process 1 with Router ID 10.110.98.138
Routing Table to ABR and ASBR
I = Intra i = Inter A = ASBR B = ABR S = SumASBR
Destination Area Cost Nexthop Interface
IA 2.2.2.2 0.0.0.0 10 10.153.17.89 Vlan-interface1
display ospf
asbr-summary
Syntax
display ospf [
process-id
] asbr-summary [
ip_address mask
]
View
All Views
Parameters
process-id
: Enter the process ID of OSPF, ranging from 1 to 65535. The
command is applied to all current OSPF processes if you do not specify a process
ID.
ip_address
Enter an IP address.
mask
Enter an IP subnet mask.
Description
Use the display ospf asbr-summary command to view the summary
information of an OSPF imported route, or all OSPF imported routes.
Tab le 25 Output Description of the ospf abr-asbr Command
Field Description
Destination Router ID of the ABR or ASBR
Area Area where the router is connected with ASBR
Cost The routing overhead value of the route
Nexthop Nexthop address to the destination
Interface The local output interface
To Next Page
Loading...
