3Com 5500G-EI - 10 USING RSTP COMMANDS; RSTP Configuration Commands

10
USING RSTP COMMANDS
This chapter describes how to use the following commands:
RSTP Configuration Commands
■ display stp
■ display stp ignored-vlan
■ display stp tc
■ reset stp
■ stp
■ stp bpdu-protection
■ stp cost
■ stp edged-port
■ stp loop-protection
■ stp ignored vlan
■ stp mcheck
■ stp mode
■ stp pathcost-standard
■ stp point-to-point
■ stp port priority
■ stp priority
■ stp root primary
■ stp root secondary
■ stp root-protection
■ stp timeout-factor
■ stp timer forward-delay
■ stp timer hello
■ stp timer max-age
■ stp transmit-limit