3Com 5500G-EI - Pim Sm; Pim Timer Hello

PIM Configuration Commands 275
[SW5500-acl-basic-2000]rule permit source 10.10.1.2 0
[SW5500-acl-basic-2000]rule deny source 10.10.1.1 0
pim sm Syntax
pim sm
undo pim sm
View
Interface View
Parameter
None
Description
Use the pim sm to enable the PIM-SM protocol on an interface.
Use the undo pim sm to disable the PIM-SM protocol.
By default, PIM-SM is disabled.
Once PIM-SM is enabled on an interface, PIM-DM cannot be enabled on the same
interface and vice versa.
Example
Enable PIM-SM on VLAN-interface10.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]multicast routing-enable
[SW5500]interface Vlan-interface-10
[SW5500-vlan-interface10]pim sm
pim timer hello Syntax
pim timer hello seconds
undo pim timer hello
View
Interface View
Parameter
seconds : Interval of sending Hello messages in second ranging from 1 to 18000.
By default, the interval value is 30 seconds.
Description
Use the pim timer hello to configure the interval of sending PIM router Hello
messages.
Use the undo pim timer hello to restore the default interval value.