3Com 5500G-EI - Display Ospf Retrans-Queue

198 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
View
All Views
Parameter
process-id : Enter the process ID of OSPF, ranging from 1 to 65535. The
command is applied to all current OSPF processes if you do not specify a process
ID.
Description
Use the display ospf request-queue command to view information about the
OSPF request-queue.
Example
To display the information on the OSPF request-queue, enter the following:
<SW5500>display ospf request-queue
The information displays in the following format:
The Router's Neighbors is
RouterID: 1.1.1.1 Address: 1.1.1.1
Interface: 1.1.1.3 Area: 0.0.0.0
LSID: 1.1.1.3 AdvRouter: 1.1.1.3 Sequence:80000017 Age:35
display ospf
retrans-queue
Syntax
display ospf [ process-id ] retrans-queue
View
All Views
Parameter
process-id : Enter the process ID of OSPF, ranging from 1 to 65535. The
command is applied to all current OSPF processes if you do not specify a process
ID.
Description
Use the display ospf retrans-queue command to view information on the
OSPF retransmission queue.
Tab le 36 Output Description of the display ospf request-queue Command
Field Description
Router ID Router ID of neighbor router
Address Address of the interface, through which neighbor routers communicate
with the router
Interface Address of the interface on the network segment
Area Area number of OSPF
LSID:1.1.1.3 Link State ID of the LSA
AdvRouter Router ID of the router originating the LSA
Sequence Sequence number of the LSA, used to discover old and repeated LSAs
Age Age of the LSA