3Com 5500G-EI - Tcp Window

142 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
Use the undo tcp timer syn-timeout command to restore the default value of
the timer.
TCP will enable the synwait timer, if a SYN packet is sent. The TCP connection will
be terminated If the response packet is not received.
Related commands: tcp timer fin-timeout, tcp window.
Example
To configure the TCP synwait timer value as 80 seconds, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]tcp timer syn-timeout 80
tcp window Syntax
tcp window window-size
undo tcp window
View
System View
Parameter
window-size Enter the size of the transmission and receiving buffers measured in
kilobytes (KB), whose value ranges from 1 to 32. By default, the window-size is
8KB.
Description
Use the tcp window command to configure the size of the transmission and
receiving buffers of the connection-oriented Socket.
Use the undo tcp window command to restore the default size of the buffer.
Related commands: tcp timer fin-timeout, tcp timer syn-timeout.
Example
To configure the size of the transmission and receiving buffers as 3KB, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]tcp window 3