3Com 5500G-EI - Igmp Enable; Igmp Group-Limit

252 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS
Example
View the IGMP configuration and running information of all interfaces.
<SW5500>display igmp interface
Vlan-interface1 (10.153.17.99):
IGMP is enabled
Current IGMP version is 2
Value of query interval for IGMP(in seconds): 60
Value of other querier time out for IGMP(in seconds): 120
Value of maximum query response time for IGMP(in seconds): 10
Value of robust count for IGMP: 2
Value of startup query interval for IGMP(in seconds): 15
Value of last member query interval for IGMP(in seconds): 1
Value of query timeout for IGMP version 1(in seconds): 400
Policy to accept IGMP reports: none
Querier for IGMP: 10.153.17.99 (this router)
IGMP group limit is 1024
No IGMP group reported
igmp enable Syntax
igmp enable
undo igmp enable
View
VLAN Interface View
Parameter
None
Description
Use the igmp enable command to enable IGMP on an interface.
Use the undo igmp enable command to disable IGMP on the interface.
By default, IGMP is disabled.
The igmp enable command can be executed only if the multicast routing function
is enabled. After multicast routing is enabled, you can initiate the IGMP feature
configuration.
Related command: multicast routing-enable
Example
Enable IGMP on Vlan-interface 10.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]interface Vlan-interface 10
[SW5500-Vlan-interface10]igmp enable
igmp group-limit Syntax
igmp group-limit number