Log Commands 465
For the related commands, see info-center enable, display info-center.
Example
Configure to send log information to the UNIX workstation at 202.38.160.1.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center loghost 202.38.160.1
info-center loghost
source
syntax
info-center loghost source
interface-name
undo info-center source
View
System view
Parameter
source
interface-name
: Sets the source address of packets sent to the loghost
as the address of the interface specified by
interface-name
. Normally, the
interface is a VLAN interface.
Description
Use the info-center loghost source command to set the source address of
packets sent to the loghost as the address of the interface specified by the
interface-name
parameter.
Use the undo info-center loghost source command to cancel the setting of
the source address of the packets sent to the loghost.
This command takes effect only after the system logging is enabled.
Related commands: info-center enable, display info-center.
Example
Set the source address of the packets sent to the loghost as the address of the
VLAN interface 1.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center loghost source vlan-interface 1
info-center monitor
channel
Syntax
info-center monitor channel {
channel-number
|
channel-name
}
undo info-center monitor channel
View
System view
Parameter
channel-number:
Channel number, ranging from 0 to 9, that is, the system has
ten channels.
To Next Page
Loading...
