3Com 5500G-EI - Display Pim Interface; Display Pim Neighbor

PIM Configuration Commands 269
Table 46 Output description of the display pim bsr command
display pim interface Syntax
display pim interface [ interface-type interface-number ]
View
All Views
Parameter
interface-type: Specifies the interface type.
interface-number: Specifies interface number.
Description
Use the display pim interface to display the PIM configuration information
about an interface.
Example
<SW5500>display pim interface
PIM information of VLAN-interface 2:
IP address of the interface is 10.10.1.20
PIM is enabled
PIM version is 2
PIM mode is Sparse
PIM query interval is 30 seconds
PIM neighbor limit is 128
PIM neighbor policy is none
Total 1 PIM neighbor on interface
PIM DR(designated router) is 10.10.1.20
display pim neighbor Syntax
display pim neighbor [ interface interface-type interface-number ]
Field Description
BSR Boot strap router
Priority Priority of BSR
Mask Length:30 Length of mask
Expires:00:01:55 Expire Time
Table 47 Output description of the display pim interface command
Field Description
PIM version Version of PIM
PIM mode PIM mode enabled on the interface (DM or SM)
PIM query interval Hello packet interval
PIM neighbor limit Limit of the PIM neighbors on an interface. No neighbor can be
added any more when the limit is reached.
PIM neighbor policy Filtering policy of the PIM neighbors on the current interface.
PIM DR Designated router.