3Com 5500G-EI - Test-Enable; Display Hwping

456 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Parameter
test-type: Test type, which can be one of the following key words:
■ dhcp: DHCP test
■ ftp: FTP connection test
■ icmp-echo: ICMP test, the default test type
■ snmpquery: SNMP test
■ tcp-private: Tests the TCP connection of a specified unknown port
■ tcp-public: Tests the TCP connection of Port 7
■ udp-private: Tests the UDP connection of a specified unknown port
■ udp-public: Tests the UDP connection of Port 7
Description
Use the test-type command to configure the type of test.
HWPing tests include DHCP, FTP, HTTP, ICMP, SNMP, TCP and UDP test. The default
test type is ICMP.
Example
Set the test type to ICMP.
[SW5500-administrator-icmp]test-type icmp-echo
test-enable Syntax
test-enable
View
HWPing Test Group View
Parameter
None
Description
Use the test-enable command to execute an HWPing test.
After executing the test-enable command, the system will not display the test
result. You may view the test result information by executing the display hwping
command.
For the related command, see display hwping.
Example
Excecute the HWPing test defined by the test group ‘wgw-testicmp’.
[SW5500-hwping-wgw-testicmp]test-enable
display hwping Syntax
display hwping { result | history } [ administrator-name
operation-tag ]