QoS Profile Configuration Commands 309
After you configure the QoS profiles and the user pass the authentication, the
Switch will deliver the right profile dynamically to the port from which the user is
accessed. The QoS profile can be delivered to the port in these different modes:
■ User-based mode: If the source station information (source MAC address,
source IP address or source MAC address + IP address) has been defined in the
ACL which is referenced in the traffic actions, the Switch cannot deliver the
QoS profile; if no source station information is available, the Switch generates a
new ACL by adding the source MAC address address and source IP address into
the existing ACL, and then delivers all traffic actions in the QoS profile to the
user port.
■ Port-based mode: The Switch delivers the traffic actions in the QoS profile
directly to the user port.
Example
To configure user-based application mode on the port, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]interface gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]qos-profile user-based
traffic-limit Syntax
traffic-limit inbound { ip-group
acl-number
[ rule
rule
[ link-group
acl-number
rule
rule
] ] | link-group
acl-number
[ rule
rule
] }
target-rate
[ exceed
action
]
undo traffic-limit inbound { ip-group
acl-number
[ rule
rule
[
link-group
acl-number
rule
rule
] ] | link-group
acl-number
[ rule
rule
] }
View
QoS Profile View
Parameter
inbound: Set traffic limiting for the inbound packets on the port.
ip-group
acl-number
: Basic or advanced ACL,
acl-number
is in the range 2000
to 3999
link-group
acl-number
: Layer 2 ACL,
acl-number
is in the range 4000 to 4999
rule
rule
: Specifies a match statement in the ACL, in the range 0 to in the range
0 to 65534. All match statements are selected if you skip this keyword.
target-rate
: The set normal traffic, unit in Kbps, the granularity of traffic limit is
64kbps, if the number input is in ( N*64 <the number input< (N+1)*64], in which
N is a natural number, the Switch automaticaly sets (N+1)*64 as the parameter
value.
target-rate
ranges for 1000 Mbps port, from 64 to 1000000 inclusive.
exceed
action
: Action taken when the traffic threshold is exceeded (optional).
Two actions are available:
To Next Page
Loading...
