EasyManua.ls Logo

3Com 5500G-EI - Ntp-Service Unicast-Peer

3Com 5500G-EI
530 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NTP Configuration Commands 511
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface1
[SW5500-Vlan-Interface1]ntp-service in-interface disable
ntp-service unicast-peer Syntax
ntp-service unicast-peer
ip-address
[ version
number
|
authentication-key
keyid
| source-interface {
interface-name
|
interface-type interface-number
} | priority ]
undo ntp-service unicast-peer
ip-address
View
System view
Parameter
ip-address
: Specify the IP address of a remote server.
version : Define NTP version number.
number
: NTP version number, ranging from 1 to 3.
authentication-key : Define authentication key.
keyid
: Key ID used for transmitting messages to a remote server, ranging from 1
to 4294967295.
source-interface : Specify the name of an interface.
interface-name
: Specify the interface name. When a local device sends an NTP
message to a peer, the source IP address of the message is taken from the address
of the interface.
interface-type
: Specify the interface type and determine an interface together
with the interface-number parameter.
interface-number
: Specify the interface number and determine an interface
together with the interface-type parameter.
priority : Designate a server as the first choice.
Description
Use the ntp-service unicast-peer command to configure NTP peer mode.
Use the undo ntp-service unicast-peer command to cancel NTP peer mode.
By default, version number
number
defaults to 3, the authentication is disabled,
and the local server is not the first choice.
This command sets the remote server at
ip-address
as a peer of the local
equipment, which operates in symmetric active mode.
ip-address
specifies a host
address other than an IP address of broadcast, multicast, or reference clock. By
operating in this mode, a local device can synchronize and be synchronized by a
remote server.
Example
Configure the local equipment to synchronize or be synchronized by a peer at
128.108.22.44. Set the NTP version to 3. The IP address of the NTP packets are
taken from that of Vlan-Interface1.

Table of Contents

Related product manuals