3Com 5500G-EI - NTP Configuration Commands; Debugging Ntp-Service

NTP Configuration Commands 501
NTP Configuration
Commands
This section describes the Network Time Protocol (NTP) configuration commands
available on your Switch 5500G-EI.
debugging ntp-service Syntax
debugging ntp-service { access | adjustment | authentication | event
| filter | packet | parameter | refclock | selection |
synchronization | validity | all }
undo debugging ntp-service { access | adjustment | authentication |
event | filter | packet | parameter | refclock | selection |
synchronization | validity | all }
View
User view.
Parameter
access: NTP access control debugging.
adjustment: NTP clock adjustment debugging.
all: All NTP debugging functions.
authentication: NTP authentication debugging.
event: NTP event debugging.
filter: NTP filter information debugging.
packet: NTP packet debugging.
parameter: NTP clock parameter debugging.
refclock: NTP reference clock debugging.
selection: NTP clock selection information debugging.
synchronization: NTP clock synchronization information debugging.
validity: NTP remote host validity debugging
Description
Use the debugging ntp-service command to debug different NTP services. Use
the
undo debugging ntp-service command to disable corresponding
debugging function.
By default, no debugging function is enabled.
Example
Enable NTP access control debugging.
<SW5500>debugging ntp-service access