3Com 5500G-EI - Terminal Debugging; Terminal Logging

472 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Parameter
None
Description
Use the reset trapbuffer command to clear information in trap buffer.
Example
Clear information in trap buffer.
<SW5500>reset trapbuffer
terminal debugging Syntax
terminal debugging
undo terminal debugging
View
User view
Parameter
None
Description
Use the terminal debugging command to configure to display the debugging
information on the terminal. Use the
undo terminal debugging command to
configure not to display the debugging information on the terminal.
By default, the displaying function is disabled.
Related commands: debugging.
Example
Enable the terminal display debugging.
<SW5500>terminal debugging
terminal logging Syntax
terminal logging
undo terminal logging
View
User view
Parameter
None
Description
Use the terminal logging command to start logging the information displayed
on the terminal. Use the
undo terminal logging command to disable terminal
log information display.