3Com 5500G-EI - Display Tcp Statistics

IP Performance Configuration Commands 137
Example
To view statistics about IP packets, enter the following:
<SW5500>display ip statistics
Input: sum 7120 local 112
bad protocol 0 bad format 0
bad checksum 0 bad options 0
Output: forwarding 0 local 27
dropped 0 no route 2
compress fails 0
Fragment:input 0 output 0
dropped 0
fragmented 0 couldn't fragment 0
Reassembling:sum 0 timeouts 0
display tcp statistics Syntax
display tcp statistics
View
Any View
Parameter
None
Table 15 Output Description of the display ip statistics Command
Field Description
Input: sum Sum of input packets
local Number of received packets whose destination is
the local device
bad protocol Number of packets with wrong protocol number
bad format Number of packets in bad format
bad checksum Number of packets with wrong checksum
bad options Number of packets that has wrong options
Output: forwarding Number of forwarded packets
local Number of packets that are sent by the local
device
dropped Number of dropped packets during transmission
no route Number of packets that cannot be routed
compress fails Number of packets that cannot be compressed
Fragment: input Number of input fragments
output Number of output fragments
dropped Number of dropped fragments
fragmented Number of packets that are fragmented
couldn't fragment Number of packets that cannot be fragmented
Reassembling: sum Number of packets that are reassembled
timeouts Number of packets that time out