Ethernet Port Configuration Commands 59
Example
Enable port loopback detection control.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]loopback-detection control enable
loopback-detection
enable
Syntax
loopback-detection enable
undo loopback-detection enable
View
Ethernet Port View
Parameter
None
Description
Use the loopback-detection enable command to enable port loopback
detection. If there is a loopback port found, the switch will put it under control.
Use the
undo loopback-detection enable command to disable port loopback
detection.
Loopback detection of a specified port only functions after port loopback
detection is enabled in the System or Ethernet port view. By default, port loopback
detection is disabled.
Related commands: display loopback-detection
Example
To enable port loopback detection, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]loopback-detection enable
loopback-detection
interval-time
Syntax
loopback-detection interval-time
time
undo loopback-detection interval-time
View
System View
Parameter
time:
Specifies the interval of monitoring external loopback conditions of the
port. It ranges from 5 to 300, measured in seconds.
To Next Page
Loading...
