3Com 5500G-EI - Display Igmp Interface

IGMP Configuration Commands 251
Parameter
group-address : Address of the multicast group.
interface-type interface-number : Interface type and interface number of the
router, used to specify the specific interface.
Description
Use the display igmp group command to view the member information of the
IGMP multicast group.
You can specify to show the information of a group or the member information of
the multicast group on an interface. The information displayed contains the
multicast groups that are joined by the downstream hosts through IGMP or
through command line.
Related command: igmp host-join.
Example
View the member information of multicast group in the system.
<SW5500>display igmp group
LoopBack0 (20.20.20.20): Total 3 IGMP Groups reported:
Group Address Last Reporter Uptime Expires
225.1.1.1 20.20.20.20 00:02:04 00:01:15
225.1.1.3 20.20.20.20 00:02:04 00:01:15
225.1.1.2 20.20.20.20 00:02:04 00:01:17
display igmp interface Syntax
display igmp interface [ interface-type interface-number ]
View
Any View
Parameter
interface-type interface-number : Interface type and interface number of the
router, used to specify the interface. If the parameters are omitted, information
about all the interfaces running IGMP will be displayed.
Description
Use the display igmp interface command to view the IGMP configuration and
running information on an interface.
Table 45 Output Display of the display igmp group Command
Field Description
Group address Multicast group address
Last Reporter The last host reporting to join in the multicast group
Uptime Time passed since multicast group is discovered (hh: mm: ss)
Expires Specifies when the member will be removed from the multicast group (hh:
mm: ss).