270 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS
View
All Views
Parameter
interface-type interface-number: Interface type and interface number, used
to specify the interface.
Description
Use the display pim neighbor to view the PIM neighbor information.
Example
<SW5500>display pim neighbor
Neighbor Address Interface Name Uptime Expires
8.8.8.6 VLAN-interface10 1637 89
display pim
routing-table
Syntax
display pim routing-table [ { { *g [
group-address
[ mask {
mask-length | mask
} ] ] | **rp [
rp-address
[ mask {
mask-length |
mask
} ] ] } | {
group-address
[ mask {
mask-length | mask
} ] |
source-address
[ mask {
mask-length | mask
} ] } * } |
incoming-interface {
interface-type interface-num | interface-name
|
null } | { dense-mode | sparse-mode } ] *
View
All views
Parameter
**rp: (*, *, RP) route entry.
*g: (*, G) route entry.
group-address:
Address of the multicast group.
source-address
: IP address of the multicast source.
incoming-interface: Router entry with the specified incoming interface.
Description
Use the display pim routing-table to view the contents of the PIM multicast
routing table.
Related command: display multicast routing-table.
Tab le 48 Output description about PIM neighbors
Field Description
Neighbor Address Neighbor address
Interface Interface where the neighbor has been discovered
Uptime Time passed since the multicast group has been discovered
Expires Specifies when the member will be removed from the group
To Next Page
Loading...
