3Com 5500G-EI - Display Qos-Interface All

QoS Configuration Commands List 291
display qos-interface all Syntax
display qos-interface { i nterface-name | interface-type
interface-num | unit-id } all
View
All views
Parameter
interface-name | interface-type interface-num : Interfaces of the Switch.
For more information, refer to the
port command in this manual.
unit-id : Unit ID of the Switch.
Description
Using the display qos-interface { i nterface-name | interface-type
interface-num | unit-id
} all command, you can view QoS information of all
interfaces. If you do not input interface parameters, this command will display all
QoS setting information for the Switch, including traffic policing, rate limit at
interface, and so on. If you input interface parameters, this command will display
QoS setting information of the specified interfaces, including traffic policing, rate
limit at interfaces, and so on.
Example
Display all the configurations of QoS parameters for unit 1.
<SW5500> display qos-interface 1 all
GigabitEthernet1/0/1: traffic-limit
Inbound:
Matches: Acl 2000 rule 1 running
Target rate: 128 Kbps
GigabitEthernet1/0/1: traffic-priority
Inbound:
Matches: Acl 2000 rule 1 running
Priority action: cos best-effort
GigabitEthernet1/0/1: line-rate
Outbound: 128 Kbps
GigabitEthernet1/0/1: traffic-statistic
Queue scheduling mode: weighted round robin
weight of queue 1: 1
weight of queue 2: 2
weight of queue 3: 3
weight of queue 4: 4
weight of queue 5: 5
weight of queue 6: 6
---- More ----
display qos-interface
line-rate
Syntax
display qos-interface { interface-name | interface-type
interface-num | unit-id } line-rate