3Com 5500G-EI - DHCP Client Configuration Commands; Debugging Dhcp Client; Debugging Dhcp Xrn Xha

116 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
Example
To configure VLAN interface 1 to obtain IP address using BOOTP, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]ip address bootp-alloc
DHCP Client
Configuration
Commands
This section describes the commands you can use to configure and manage the
Dynamic Host Configuration Protocol (DHCP) Client operations on your Switch
5500G-EI.
debugging dhcp client Syntax
debugging dhcp client { all | error | event | packet }
undo debugging dhcp client { all | error | event | packet }
View
User view
Parameters
all Enter to enable all DHCP client debugging.
error Enter to enable DHCP client error (including packet unrecognizable )
debugging.
event Enter to enable DHCP client event (including address allocation and data
update) debugging.
packet Enter to enable DHCP client packet debugging.
Description
Use the debugging dhcp client command to enable DHCP client debugging.
Use the undo debugging dhcp client command to disable DHCP client
debugging.
By default, all DHCP client debugging is disabled.
Example
To enable DHCP client event debugging, enter the following:
<SW5500>debugging dhcp client event
debugging dhcp xrn xha Syntax
debugging dhcp xrn xha
undo debugging dhcp xrn xha
View
User view