OSPF Configuration Commands 195
seq#: 80000001
chksum: 0xfcaf
Options: (DC)
Net mask: 255.255.0.0
Tos 0 metric:1
E type:2
Forwarding Address:0.0.0.0
Tag: 1
display ospf nexthop Syntax
display ospf [
process-id
] nexthop
View
All Views
Parameter
process-id
Enter the process ID of OSPF, ranging from 1 to 65535. The command
is applied to all current OSPF processes if you do not specify a process ID.
Description
Use the display ospf nexthop command to view the information about the
next-hop.
Example
To display the OSPF next-hop information, enter the following:
<SW5500>display ospf nexthop
OSPF Process 1 with Router ID 1.1.1.1
The information displays in the following format:
Address Type Refcount Intf Addr Intf Name
--------------------------------------------------------------------
202.38.160.1 Direct 3 202.38.160.1 Vlan-interface2
202.38.160.2 Neighbor 1 202.38.160.1 Vlan-interface2
Table 32 Output Description of the display ospf lsdb ase Command
Field Description
type Type of the LSA
ls id Link state ID of the LSA
adv rtr Router ID of the router originating the LSA
ls age Age of the LSA
len Length of the LSA
Seq# Sequence number of the LSA
chksum Checksum of the LSA
Options Options of the LSA
Net mask Network mask
E type Type of external route
Forwarding Address Forwarding address
Tag Tag
To Next Page
Loading...
