212 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Vlan-interface 1
[SW5500-Vlan-interface1]ospf timer hello 20
ospf timer poll Syntax
ospf timer poll
seconds
undo ospf timer poll
View
VLAN Interface view
Parameter
seconds
Enter the the poll Hello interval in seconds, in the range 1 to 65535. The
default value is 120 seconds.
Description
Using the ospf timer poll command, you can configure the Hello packet poll
interval.
Using the undo ospf timer poll command, you can restore the default poll
interval.
The Poll interval should be at least three times the Hello interval.
Example
To set the transmit poll Hello packet interval to 130 seconds for interface
Vlan-interface 2, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Vlan-interface 2
[SW5500-Vlan-interface2]ospf timer poll 130
ospf timer retransmit Syntax
ospf timer retransmit
interval
undo ospf timer retransmit
View
VLAN Interface view
Parameter
interval
Enter the interval allowed before LSA re-transmission. This time is set for
an interface, in seconds, in the range 1 to 65535. The default value is 5 seconds.
Description
Using the ospf timer retransmit command, you can configure the interval
before LSA re-transmission on an interface.
To Next Page
Loading...
