3Com 5500G-EI - Display Pim Bsr-Info

268 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS
mrt: debugging information of PIM-SM multicast routing table.
timer: debugging information of PIM-SM timer.
warning: debugging information of PIM-SM warning message.
recv: debugging information of PIM-SM receiving packets.
send: debugging information of PIM-SM sending packets.
alert | fresh: debugging information of PIM-SM multicast border router event.
assert | boostrap | crpadv | jp | reg | regstop: packets type.
assert | bsr | crpadv | jp | jpdelay | mrt | probe | spt: debugging
information of PIM-SM timer.
Description
Use the debugging pim sm to enable PIM-SM debugging functions.
Use the undo debugging pim sm to disable the debugging functions.
By default, PIM-SM debugging functions are disabled.
Example
Enable all PIM-SM debugging functions
[SW5500]debugging pim sm all
display pim bsr-info Syntax
display pim bsr-info
View
All Views
Parameter
None
Description
Use the display pim bsr-info to display the BSR information.
Related command: c-bsr, c-rp.
Example
<SW5500>display pim bsr-info
Current BSR Address: 20.20.20.30
Priority: 0
Mask Length: 30
Expires: 00:01:55
Local host is BSR