PIM Configuration Commands 277
neighbor-address
: Specifies neighbor address.
interface
interface-type
interface-number
: Specifies interface.
Description
Use the reset pim neighbor command to clear a PIM neighbor.
Related command: display pim neighbor
Example
Clear the PIM neighbor 25.5.4.3.
<SW5500>reset pim neighbor 25.5.4.3
reset pim routing-table Syntax
reset pim routing-table { all | {
group-address
[ mask {
group-mask
|
group-mask-length
}] |
source-address
[ mask {
source-mask
|
source-mask-length
}] | { incoming-interface {
interface-type
interface-number
| null } } } * }
View
User View
Parameter
all: All PIM neighbors
group-address:
Specifies group address.
mask
group-mask
: Specifies group mask.
mask-length
group-mask-length
: Specifies mask length of the group address.
source-address
: Specifies source address.
mask
source-mask
: Specifies source mask.
mask-length
source-mask-length
: Specifies mask length of the group address.
incoming-interface: Specifies incoming interface for the route entry in PIM
routing table.
interface-type interface-number
: Specifies the interface.
null: Specifies the incoming interface of the route entry as null.
Description
Use the reset pim routing-table command to clear a PIM route entry.
You can type in
source-address
first and
group-address
after in the command,
as long as they are valid. Error information will be given if you type in invalid
addresses.
If in this command, the group-address is 224.0.0.0/24 and source-address is the
RP address (where group address can have a mask, but the resulted IP address
To Next Page
Loading...
