3Com 5500G-EI - MAC Address Table Management Commands; Display Mac-Address

MAC Address Table Management Commands 431
View
User view
Parameter
tftp-server : IP address or hostname of the TFTP server. The name of the TFTP
server should be a string ranging from 1 to 20 characters.
source-file : Specify the filename of the source file which is saved on the switch.
dest-file : Specify the filename of the destination file which will be saved on the
TFTP server.
Description
Use the tftp put command to upload a file from the switch to the specified
directory on the TFTP server and save it with a new name.
Related commands: tftp get.
Example
<SW5500>tftp 1.1.3.214 put sw5500cfg.txt temp.txt
MAC Address Table
Management
Commands
This section describes the commands you can use to manage the MAC Address
Table on your Switch 5500G-EI.
display mac-address Syntax
display mac-address [ mac-addr [ vlan vlan-id ] | [ static | dynamic
| blackhole ] [ interface { interface-name | interface-type
interface-num } ] [ vlan vlan-id ] [ count ] ]
View
All views
Parameter
mac-addr : Specify the MAC address.
vlan-id : Specify the VLAN ID.
static: Static table entry, lost after resetting switch.
dynamic: Dynamic table entry, which will be aged.
blackhole: Blackhole table entry, the packet with this destination MAC address
will be discarded.
interface-type: Specify the interface type.
interface-num: Specify the interface number.
interface-name: Specify the interface name.