32 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
Mode 2: Input in several lines
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]header shell % SHELL:
After you pressing the <Enter> key, the system prompts the following message:
Input banner text, and quit with the character '%'.
Go on inputting the rest text and end your input with the first letter:
Hello! Welcome %
Press the <Enter> key.
[SW5500]
When you log on the Switch again, the terminal displays the configured session
establishment title.
[SW5500]quit
<SW5500>quit
Please press ENTER
%SHELL:
The initial character "%" is the header contents.
Hello! Welcome
<SW5500>
history-command
max-size
Syntax
history-command max-size
value
undo history-command max-size
View
User interface view
Parameter
value:
Enter the number of previously entered commands that you want the
Switch to save.
Description
Use the command history-command max-size to specify the amount of
previously entered commands that you want the Switch to save. Enter any value
between 0 and 256. The default is 10, that is, the 10 most recently entered
commands are saved. Use the
undo history-command max-size command to
restore the default value.
To display the most recently-entered commands, up to the specified maximum,
use the command
display history-command.
Example
To set the history buffer to 20, that is to save the 20 most recently-entered
commands, enter the following:
To Next Page
Loading...
