304 CHAPTER 8: USING QOS/ACL COMMANDS
[SW5500]interface gigabitethernet 1/0/1
[SW5500-Ethernet1/0/1]traffic-priority inbound ip-group 2000 cos 0
traffic-redirect Syntax
traffic-redirect inbound { ip-group
acl-number
[ rule
rule
[
link-group
acl-number
rule
rule
] ] | link-group
acl-number
[ rule
rule
] } { cpu | interface {
interface-name | interface-type
interface-num
} }
undo traffic-redirect inbound | { ip-group
acl-number
[ rule
rule
[
link-group
acl-number
rule
rule
] ] | link-group
acl-number
[ rule
rule
] }
View
Ethernet Port View
Parameter
inbound: Performs traffic redirecting on the packets received by the interface.
ip-group
acl-number
: Activates IP ACLs, including basic and advanced ACLs.
acl-number
: Sequence number of ACL, ranging from 2000 to 3999.
link-group
acl-number
: Activates Layer 2 ACLs.
acl-number
: Sequence number
of ACL, ranging from 4000 to 4999.
rule
rule
: Specifies the subitem of an active ACL, ranging from 0 to 65534; if not
specified, all subitems of the ACL will be activated. If only an IP ACL or a Layer 2
ACL is activated, this parameter can be omitted. If both IP and Layer 2 ACLs are
activated at the same time, the
rule
parameter cannot be omitted.
cpu: Configures to redirect the traffic to the CPU.
interface
{ interface-name | interface-type interface-num }
: Specifies
the Ethernet port to which the packets will be redirected.
interface-type
specifies the port type.
interface-num
specifies the port number.
interface-num
and
interface-type
specify a complete port name together.
interface-name
is
interface-type
added with
interface-num
.
Description
Use the traffic-redirect command to activate the ACL to recognize and
redirect the traffic (whose action is permit). Use the
undo traffic-redirect
command to cancel the redirection.
You can only redirect traffic within the same unit. That is to say that if you receive
traffic on port 2/0/1 you can only redirect it to another port in unit 2.
For the related command, see display qos-global traffic-redirect.
Example
Redirects the packets matching the ACL 2000 rules with action permit to the port
GigabitEthernet1/0/1.
<SW5500>system-view
System View: return to User View with Ctrl+Z
To Next Page
Loading...
