ARP Configuration Commands 111
display arp timer aging Syntax
display arp timer aging
View
All views.
Parameter
None.
Description
Use the display arp timer aging command to view the current setting of the
dynamic ARP aging timer.
Example
To display the current setting of the dynamic ARP aging timer, enter the following:
<SW5500>display arp timer aging
The information displays in the following format:
Current ARP aging time is 10 minute(s)
reset arp Syntax
reset arp [ dynamic | static | interface {
interface_type
interface_num
|
interface_name
} ]
View
User view
Parameters
dynamic
Enter to clear the dynamic ARP mapping entries. Note that dynamic ARP
entries start re-learning immediately.
static
Enter to clear the static ARP mapping entries. Note that static ARP entries
are deleted permanently.
interface
interface_type interface_num interface_name
Enter to clear the
ARP mapping entries for the specified port.
Table 10 Output Description of the display arp Command
Field Description
IP Address IP address of the ARP mapping entry
MAC Address MAC address of the ARP mapping entry
VLAN ID VLAN to which the static ARP entry belongs
Port Name Port to which the static ARP entry belongs
Aging Aging time of dynamic ARP entry in minutes
Typ e Type of ARP entry
To Next Page
Loading...
