MAC Address Table Management Commands 433
The above information indicates that the dynamic entry in the MAC address table
is no-aging.
mac-address Syntax
mac-address { static | dynamic | blackhole }
mac-address
interface {
interface
-
name
|
interface
-
type
interface
-
num
} vlan
vlan
-
id
undo mac-address [ { static | dynamic | blackhole }
mac
-
address
interface {
interface
-
name
|
interface
-
type
interface
-
num
] vlan
vlan
-
id
]
View
System view
Parameter
static: Static table entry, lost after resetting switch.
dynamic: Dynamic table entry, which will be aged.
blackhole: Blackhole table entry, the packet with this destination MAC address
will be discarded.
mac-addr:
Specify the MAC address.
interface-type:
Specify the interface type.
interface-num:
Specify the interface number.
interface-name:
Specify the interface name.
vlan-id:
Specify the VLAN ID.
Description
Use the mac-address command to add/modify the MAC address table entry. Use
the
undo mac-address command to delete MAC address table entry
If the input address has been existing in the address table, the original entry will be
modified. That is, replace the interface pointed by this address with the new
interface and the entry attribute with the new attribute (dynamic entry and static
entry).
All the (MAC unicast) addresses on a certain interface can be deleted. User can
choose to delete any of the following addresses: address learned by system
automatically, dynamic address configured by user, static address configured by
user.
For the related commands, see display mac-address.
Example
Configure the port number corresponding to the MAC address 00e0-fc01-0101 as
Gigabit
Ethernet1/0/1 in the address table, and sets this entry as static entry.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
To Next Page
Loading...
