3Com 5500G-EI - Display Dhcp-Server Interface Vlan-Interface

DHCP Relay Configuration Commands 123
Description
Use the display dhcp-server command to view information on a selected DHCP
Server group.
Related commands: dhcp-server ip, dhcp-server, display dhcp-server
interface vlan-interface
, debugging dhcp-relay.
Example
To view information on DHCP Server group 0, enter the following:
<SW5500>display dhcp-server 0
The information displays in the following format:
The first IP address of DHCP Server group 0: 1.1.1.1
The second IP address of DHCP Server group 0: 1.1.1.2
Messages from this server group: 0
Messages to this server group: 0
Messages from clients to this server group: 0
Messages from this server group to clients: 0
DHCP_OFFER messages: 0
DHCP_ACK messages: 0
DHCP_NAK messages: 0
DHCP_DECLINE messages: 0
DHCP_DISCOVER messages: 0
DHCP_REQUEST messages: 0
DHCP_INFORM messages: 0
DHCP_RELEASE messages: 0
BOOTP_REQUEST messages: 0
BOOTP_REPLY messages: 0
display dhcp-server
interface vlan-interface
Syntax
display dhcp-server interface vlan-interface vlan_id
Views
All views
Parameter
vlan_id Enter the VLAN interface number.
Description
Use the display dhcp-server interface vlan-interface command to display
the information on the DHCP Server group corresponding to a specific VLAN
interface.
Related commands: dhcp-server, display dhcp-server, debugging
dhcp-relay
.
Example
To view the information on the DHCP Server group corresponding to
VLAN-Interface 2, enter the following:
<SW5500>display dhcp-server interface vlan-interface 2