3Com 5500G-EI - Rsa Peer-Public-Key; Ssh Server Authentication-Retries

520 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Acknowledgement information will be promoted before the system clears all RSA
key pairs. This command is just a one-time instruction, so the result will not be
stored in the configuration file.
Related command: rsa local-key-pair create.
Example
To remove all key pairs at the server, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rsa local-key-pair destroy
% The name for the keys which will be destroyed is SW5500_Host .
% Confirm to destroy these keys? [yes/no]:y
rsa peer-public-key Syntax
rsa peer-public-key key-name
View
System view
Parameter
key-name : Public key name
Description
Use the rsa peer-public-key command to enter the public key view.
When using this command together with the public-key-code begin command to
configure the public key at the client, which is generated randomly by the client
program supporting SSH1.5.
Related commands: public-key-code begin, public-key-code end.
Example
To enter the public key view, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rsa peer-public-key 3COM002
ssh server
authentication-retries
Syntax
ssh server authentication-retries times
undo ssh server authentication-retries
View
System view
Parameter
times : Specifies authentication retry times, in the range of 1~5.