3Com 5500G-EI - Display Poe Interface Power

PoE Configuration Commands 93
GigabitEthernet1/0/15 off enable signal low Detection
GigabitEthernet1/0/16 off enable signal low Detection
GigabitEthernet1/0/17 off enable signal low Detection
GigabitEthernet1/0/18 off enable signal low Detection
GigabitEthernet1/0/19 off enable signal low Detection
GigabitEthernet1/0/20 off enable signal low Detection
GigabitEthernet1/0/21 off enable signal low Detection
GigabitEthernet1/0/22 off enable signal low Detection
GigabitEthernet1/0/23 off enable signal low Detection
GigabitEthernet1/0/24 off enable signal low Detection
GigabitEthernet1/0/25 off disable signal low User set off
GigabitEthernet1/0/26 off disable signal low User set off
GigabitEthernet1/0/27 off disable signal low User set off
GigabitEthernet1/0/28 off disable signal low User set off
GigabitEthernet1/0/29 off disable signal low User set off
GigabitEthernet1/0/30 off disable signal low User set off
GigabitEthernet1/0/31 off disable signal low User set off
GigabitEthernet1/0/32 off disable signal low User set off
GigabitEthernet1/0/33 off disable signal low User set off
GigabitEthernet1/0/34 off disable signal low User set off
GigabitEthernet1/0/35 off disable signal low User set off
GigabitEthernet1/0/36 off disable signal low User set off
GigabitEthernet1/0/37 off disable signal low User set off
GigabitEthernet1/0/38 off disable signal low User set off
GigabitEthernet1/0/39 off disable signal low User set off
GigabitEthernet1/0/40 off disable signal low User set off
GigabitEthernet1/0/41 off disable signal low User set off
GigabitEthernet1/0/42 off disable signal low User set off
GigabitEthernet1/0/43 off disable signal low User set off
GigabitEthernet1/0/44 off disable signal low User set off
GigabitEthernet1/0/45 off disable signal low User set off
GigabitEthernet1/0/46 off disable signal low User set off
GigabitEthernet1/0/47 off disable signal low User set off
GigabitEthernet1/0/48 off disable signal low User set off
display poe interface
power
Syntax
display poe interface power [ interface-name | interface-type
interface-num ]
View
Any view
Parameter
interface-name | interface-type interface-num: Port on the Switch.
Description
Use the display poe interface power command, you can view the power
information of a specific port or all ports on the switch.
Example
Display the power information of port GigabitEthernet1/0/10.
[SW5500]display poe interface power gigabitethernet1/0/10