3Com 5500G-EI - If-Match Tag; Ip Ip-Prefix

228 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
[SW5500]route-policy permit node 1
% New sequence of this list
[SW5500-route-policy]if-match ip next-hop ip-prefix p1
if-match tag Syntax
if-match tag value
undo if-match tag
View
Route Policy view
Parameter
value Enter the value in tag field of OSPF route information.
Description
Use the if-match tag command to match the tag field of OSPF route
information.
Use the undo if-match tag command to cancel the existing matching rules.
Related commands: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, route-policy, apply ip next-hop,
apply cost, apply local-preference, apply origin
and apply tag.
Example
Define one match sub-statement and enable the OSPF route information whose
value of tag is 8 to pass the match sub-statement.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]route-policy permit node 1
% New sequence of this list
[SW5500-route-policy]if-match tag 8
ip ip-prefix Syntax
ip ip-prefix ip_prefix_name [ index index_number ] { permit | deny }
network len [ greater-equal greater_equal | less-equal less_equal ]
undo ip ip-prefix ip_prefix_name [ index index_number | permit | deny
]
View
System View
Parameter
ip_prefix_name Enter the specified address prefix list name. It identifies one
address prefix list uniquely.
index_number Identify an item in the prefix address list. The item with smaller
index-number will be tested first.