3Com 5500G-EI - Lacp Enable; Lacp Port-Priority

74 CHAPTER 2: USING PORT COMMANDS
Description
Use the display lacp system-id command to view actor system ID, including
system priority and system MAC address.
Related command: link-aggregation.
Example
To display the local system ID.
<SW5500>display lacp system-id
Actor System ID: 0x8000, 00e0-fc00-0100
lacp enable Syntax
lacp enable
undo lacp enable
View
Ethernet Port View
Parameter
None
Description
Use the lacp enable command to enable LACP.
Use the undo lacp enable command to disable LACP.
Example
To enable LACP at Ethernet1/0/1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]lacp enable
lacp port-priority Syntax
lacp port-priority port-priority-value
undo lacp port-priority
View
Ethernet Port View
Parameter
port-priority-value: Port priority, ranging from 0 to 65535. By default, it is
32768.