150 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
mask
Enter either the IP subnet mask (in x.x.x.x format), or the subnet mask length
(in the range 0 to 32). Optional.
longer-match Enter to display an address route that matches the destination IP
address in natural mask range . Optional.
verbose Enter to display verbose information about both active and inactive
routes. Without this parameter, this command only displays a summary of active
routes. Optional.
Description
Use the display ip routing-table ip_address command to view routing
information for a specific IP address, and you can also choose the type of
information to display. If the destination address,
ip_address
, has a
corresponding route in natural mask range, this command will display all subnet
routes or only the route best matching the destination address,
ip_address
, is
displayed. And only the active matching route is displayed.
Use the display ip routing-table
ip_address
mask
command to display the
route that matches the specified IP destination address and subnet mask.
Use the display ip routing-table
ip_address
longer-match command to
display all destination address routes that match destination IP addresses in natural
mask range.
Use the display ip routing-table
ip_address
verbose command to display
verbose information about both active and inactive routes.
Example
There is corresponding route in natural mask range. Display the summary.
<SW5500>display ip routing-table 169.0.0.0
Routing Tables:
Summary count:1
Destination/Mask Proto Pre Cost Nexthop Interface
169.0.0.0/16 Static 60 0 2.1.1.1 LoopBack1
There are corresponding routes in the natural mask range. Display the detailed
information.
<SW5500>display ip routing-table 169.0.0.0 verbose
Routing Tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both* = Next hop in use
Summary count:2
**Destination: 169.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Cost: 0/0
**Destination: 169.0.0.0 Mask: 255.254.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
To Next Page
Loading...
