7
USING MULTICAST PROTOCOL
COMMANDS
This chapter describes how to use the following commands:
IGMP Snooping Configuration Commands
■ display igmp-snooping configuration
■ display igmp-snooping group
■ display igmp-snooping statistics
■ igmp-snooping
■ igmp-snooping host-aging-time
■ igmp-snooping max-response-time
■ igmp-snooping router-aging-time
■ reset igmp-snooping statistics
Multicast Common Configuration Commands
■ debugging multicast forwarding
■ debugging multicast kernel-routing
■ debugging multicast status-forwarding
■ display multicast forwarding-table
■ display multicast routing-table
■ mtracert
■ multicast route-limit
■ multicast routing-enable
■ reset multicast forwarding-table
■ reset multicast routing-table
IGMP Configuration Commands
■ debugging igmp
■ display igmp group
■ display igmp interface
■ igmp enable
■ igmp group-limit
■ igmp group-policy
■ igmp group-policy vlan
■ igmp host-join
To Next Page