3Com 5500G-EI - Page 320

324 CHAPTER 10: USING RSTP COMMANDS
display stp ignored-vlan Syntax
display stp ignored-vlan
View
Any view
Parameter
None
Description
Use the display stp ignored-vlan command to view the list of STP-Ignored
VLANs.
After a STP-Ignored VLAN is configured, the packets of this VLAN will be
forwarded on any Switch port, with no restriction from the calculated STP path.
Example
To display the list of STP-Ignored VLANs, enter the following:
<SW5500>display stp ignored-vlan
STP-Ignored VLAN: 10, 20, 30, 40
display stp tc Syntax
display stp tc
View
All views
Parameter
None
Description
Use the display stp tc command to display the number of topology changes
and/or topology change notifications that an active port has recieved.
Related command: reset stp.
Example
To display the number of topology changes and/or notifications , enter the
following:
<SW5500>display stp stc
-------Stp port received--------- TC-----or----- TCN----count-
reset stp Syntax
reset stp [ interface interface_list ]
View
User view