3Com 5500G-EI - 9 USING FABRIC COMMANDS; Fabric Configuration Commands

9
USING FABRIC COMMANDS
This chapter describes how to use the following commands:
Fabric Configuration Commands
■ display xrn-fabric
■ change self-unit
■ change unit-id
■ set unit name
■ sysname
Fabric Commands This section describes how to use the Fabric configuration commands on your
Switch 5500G-EI.
display xrn-fabric Syntax
display xrn-fabric
View
Any view
Parameter
None
Description
Use the display xrn-fabric command to view the information of the entire
fabric, including unit ID, unit name, operation mode and the roll of a device
(master or slave). An asterisk (*) is used to indicate which unit you have connected
to via a console connection.
Example
To display fabric information, enter the following:
[SW5500]display xrn-fabric
Fabric name is SW5500 , system mode is L3.
Fabric authentication: NOT SUPPORT, unit number: 1.
Unit Name Unit ID
SW5500 1(*)
change self-unit Syntax
change self-unit to { 1 | auto-numbering }