52 CHAPTER 2: USING PORT COMMANDS
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc00-0010
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 1000_BASE_T
Unkown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is
autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1536
Broadcast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input: 0 packets/sec 0 bytes/sec
Last 300 seconds output: 0 packets/sec 0 bytes/sec
Input(total): 0 packets, 0 bytes
- broadcasts, - multicasts
Input(normal): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles, 0 CRC
frame, - overruns, 0 aborts, - ignored, - parity errors
Output(total): 0 packets, 0 bytes
- broadcasts, - multicasts, - pauses
Output(normal): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
- aborts, 0 deferred, 0 collisions, 0 late collisions
- lost carrier, - no carrier
Tab le 6 Output Description of the Display Interface Command
Field Description
Ethernet1/0/1 current state Indicates the current state of the Ethernet port (up
or down)
IP Sending frames’ format Displays the Ethernet frame format
Hardware address Displays the port hardware address
Description Displays the port description
The Maximum Transmit Unit Indicates the maximum transmit unit
Media type Indicates the type of media
loopback not set Displays the port loopback test state
Port hardware type Displays the port hardware type
Unknowns-speed mode,
unknown-duplex mode, link speed type
is autonegotiation, link duplex type is
autonegotiation
Both the duplex mode and the rate are set to
auto-negotiation.
Flow control is not enabled Port flow control state
The Maximum Frame Length Indicates the maximum length of the Ethernet
frames that can pass through the port
Broadcast MAX ratio Port broadcast storm suppression ratio
Allow jumbo frame to pass Indicates that jumbo frame are allowed to pass
through the port
To Next Page
Loading...
