3Com 5500G-EI - Page 9

preference 214
reset ospf 215
router id 215
silent-interface 216
snmp-agent trap enable ospf 217
spf-schedule-interval 218
stub 218
vlink-peer 219
IP Routing Policy Configuration Commands 220
apply cost 220
apply tag 221
display ip ip-prefix 222
display route-policy 222
filter-policy export 223
filter-policy import 224
if-match { acl | ip-prefix } 225
if-match cost 226
if-match interface 226
if-match ip next-hop 227
if-match tag 228
ip ip-prefix 228
route-policy 229
Route Capacity Configuration Commands 231
display memory 231
display memory limit 231
memory auto-establish disable 232
memory auto-establish enable 233
memory { safety | limit } 233
7 USING MULTICAST PROTOCOL COMMANDS
IGMP Snooping Configuration Commands 237
display igmp-snooping configuration 237
display igmp-snooping group 237
display igmp-snooping statistics 238
igmp-snooping 239
igmp-snooping host-aging-time 239
igmp-snooping max-response-time 240
igmp-snooping router-aging-time 241
reset igmp-snooping statistics 241
Multicast Common Configuration Commands 242
debugging multicast forwarding 242
debugging multicast kernel-routing 242
debugging multicast status-forwarding 243
display multicast forwarding-table 243
display multicast routing-table 244
mtracert 246
multicast route-limit 247