Fujitsu Oracle SPARC M12-2 User Manual

Table 4-22
Active/Cold Replacement Procedure of the XSCF BB Control Cable (conti nued)
Work
Order
Task Reference
11 Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
"10.6.1 Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR DR"
12 Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain
"10.7 Incorporating I/O Resources Into a
Logical Domain"
13 Checking the operating condition of the
system
and the I/O device usage status
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle Solaris"
4.3 Inactive/Hot Replacement Workflows
This section describes the workflows for active/hot replacement of the FRUs mounted
in the SPARC M12-2S.
You can perform inactive/hot replacement only in the following configuration:
■
Building block configuration where two or more physical partitions are operating
Before performing replacement work, be sure to check the notes on maintenance
work in the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the tasks for each
FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to inactive/hot replacement:
■
XSCFU
■
PCIe card
■
PSU
■
FANU
■
HDD/SSD
■
PCI expansion unit
4.3.1 Inactive/Hot Replacement Workflow of the XSCFU
You can perform inactive/hot replacement of the XSCFU in the following configuration:
■
Building block configuration where two or more physical partitions are operating
Before replacing the XSCFU, see "Precautions for XSCFU and PSUBP replacement" in
"7.1 Precautions for FRU Replacement."
Table 4-23 shows the workflow for inactive/hot replacement of the XSCFU.
Chapter 4 FRU Replacement Workflows 97

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English