Fujitsu Oracle SPARC M12-2 User Manual

Note -
When removing the SPARC M12-2S due to a change in the building block configuration,
be sure to perform the procedure described below.
XSCF>
showbbstatus
BB#00 (Master)
←
(*1)
XSCF>
*1 If the XSCF you have logged in to is in the standby state, Standby is displayed.
XSCF>
showboards -a -v
PSB R PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- - ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
02-0 SP Available n n n Passed Normal
←
(*1)
XSCF>
*1 If Available or Unavailable is not displayed under Assignment, release the PSB from the physical partition.
9.7 Removing the SPARC M12-2S
This section describes the procedure for releasing the SPARC M12-2S from a building
block configuration.
Before removing the SPARC M12-2S, make sure that it is not assigned to any physical
partition.
For details on the commands used here, see the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 XSCF Reference Manual of the
XCP version used.
1.
Log in to the master XSCF.
After logging in to the XSCF shell, you can check whether it is in the master
state, by using the showbbstatus command.
2.
Check the status of the target SPARC M12-2S.
Log in to the master XSCF, and check that the target SPARC
M12-2S is not used.
3.
Delete the CPU Activation key.
Delete the CPU Activation key of the target SPARC M12-2S.
Regarding CPU resources assigned to logical domains, release from the logical
domains the assignment of as many CPU resources as the number of CPU
Activation keys to be deleted. After that, delete the
CPU Activation keys.
For details, see "Chapter 5 CPU Activation" in the Fujitsu SPARC M12 and
Fujitsu M10/SPARC M10 System Operation and Administration Guide.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023318

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English