Fujitsu Oracle SPARC M12-2 User Manual

primary#
ldm add-io PCIE10 primary
primary#
primary#
shutdown -i6 -g0 -y
Note -
If the delayed reconfiguration mode is set for the control domain, the ldm command
cannot be used for any logical domain other than the control domain. When you have set the
delayed reconfiguration mode for the control domain, restart the control domain immediately
after changing the control domain setting.
Table 10-2
Procedure for Incorporating the Root Complex Into the Stopped Root Domain
Item Task Command
1 Assigning the physical I/O device (root complex) to the
root domain
ldm add-io
2Starting the root domain ldm start-domain
#
ldm add-io <root complex name> <root domain name>
in any logical domain.
3.
Restart Oracle Solaris on the control domain or root domain for which the
delayed reconfiguration mode has been set.
Restart Oracle Solaris on the control domain or root domain for which the
delayed reconfiguration mode has been set.
In this example, Oracle Solaris on the control domain
is restarted.
Note that this step is not necessary when the root complex has been assigned to
the logical domain using dynamic PCIe bus assignment.
10.7.2 Incorporating the Root Complex Into the Stopped
Root Domain
Incorporate the physical I/O device (root complex) released from the root domain
into the stopped root domain.
The procedure for statically reconfiguring a root complex is described below.
1.
Reassign the I/O device (PCIe root complex) released from the root domain to
the root domain.
2.
Start the root domain.
This step is unnecessary
when the root complex is reconfigured dynamically.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023362

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English