Fujitsu Oracle SPARC M12-2 User Manual

Note -
Before stopping the system, check with the system administrator or the logical domain
administrator about whether you can stop the logical domain.
Note -
From the OPNL, you cannot instruct the system to stop a specific physical partition.
Table 9-12
Procedure for Stopping a Specific Physical Partition
Step Operation Description Command Used
1 Checking the operation status of
physical partitions
XSCF> showpparstatus -a
2 Checking the operation status of the
logical domains on the target physical
partition
XSCF> showdomainstatus -p <ppar_id>
3 Checking the status of the SPARC
M12-2S requiring maintenance
XSCF> showboards -p <ppar_id>
4 Stopping the physical partition XSCF> poweroff -p <ppar_id>
5 Checking the stop processing
status of
the physical partition
XSCF> showpparprogress -p <ppar_id>
6 Confirming that the target physical
partition has stopped
XSCF> showpparstatus -a
9.5 Stopping the System
For hardware maintenance and for changing the hardware configuration, it is
necessary to stop the system depending on the FRU requiring maintenance and the
system configuration.
This section describes the following procedures for stopping the system:
■
Stopping a Specific Physical Partition
■
Stopping All Physical Partitions
9.5.1 Stopping a Specific Physical Partition
This section describes the procedure for stopping a specific physical partition in a
system with a building block configuration.
The operations described here are possible only from the XSCF shell. Table 9-12 lists
the procedure after login to the master XSCF.
The following example executes the commands for stopping PPAR-ID#00.
1.
Check the
operation status of physical partitions.
The following example checks the operation status of the physical partition of
Chapter 9 Releasing FRUs From the System 305

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English