Fujitsu Oracle SPARC M12-2 User Manual

DR sequence finished (sequence#=2, message#=3)
..
Processing of the incoming DR request by the LDoms Manager is pendingIncoming
DR request is being processed by the LDoms ManagerDR sequence started
(sequence#=3, message#=2)
DR sequence finished (sequence#=3, message#=2)
.end
Unconfigured PSB from PPAR.
PSB power off sequence started. [1200sec]
0..... 30..... 60..... 90.....120.....150...end
Operation has completed.
Note -
You may need to assign command options depending on how the DR is used and the
logical domain system configuration.
For details on command options, see "3.1.16 Deleting a System Board From a Building
Block Configuration" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Domain
Configuration Guide.
XSCF>
showresult
0
Note -
For information on the action to take if the deleteboard command ends abnormally,
see "3.1.16 Deleting a System Board From a Building Block Configuration" in the Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration Guide.
XSCF>
showboards -va
PSB R PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- - ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 * 00(01) Assigned n n n Passed Normal
XSCF>
11.
Check the end code of the deleteboard command.
If the end code is not 0, the deleteboard command ended abnormally. Eliminate
the cause of the failure, and then execute the deleteboard command again.
In the following example, "0" is returned as the end status, so you can see that
the execution
of the deleteboard command has completed correctly.
12.
Confirm that the SPARC M12-2S of BB-ID#01 has been powered off and that
the system board is in the pool state.
Since the SPARC M12-2S has been released with the disconnect option,
incorporation into PPAR ID#00 is reserved.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023304

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English