Fujitsu Oracle SPARC M12-2 - 10.6 Incorporating the SPARC M12-2 S or an I;O Device Into the PPAR; 10.6.1 Incorporating the SPARC M12-2 S Into the Physical Partition Using PPAR DR

PSUBP Status:Normal; Ver:1101h; Serial:PP164603HH ;
+ FRU-Part-Number:CA20369-B17X 005AC/7341758 ;
+ Type: C ;
PSU#0 Status:Normal; Ver:303242h; Serial:HWCD1622000551;
+ FRU-Part-Number:CA01022-0850/7334651 ;
+ Power_Status:ON; AC:200 V; Type: C ;
PSU#1 Status:Normal; Ver:303242h; Serial:HWCD1622000586;
+ FRU-Part-Number:CA01022-0850/7334651 ;
+ Power_Status:ON; AC:200 V; Type: C ;
PSU#2 Status:Normal; Ver:303242h; Serial:HWCD1622000524;
+ FRU-Part-Number:CA01022-0850/7334651 ;
+ Power_Status:ON;
AC:200 V; Type: C ;
PSU#3 Status:Normal; Ver:303242h; Serial:HWCD1622000496;
+ FRU-Part-Number:CA01022-0850/7334651 ;
+ Power_Status:ON; AC:200 V; Type: C ;
FANU#0 Status:Normal; Type: C ;
FANU#1 Status:Normal; Type: C ;
FANU#2 Status:Normal; Type: C ;
FANU#3 Status:Normal; Type: C ;
FANU#4 Status:Normal; Type: C ;
FANU#5 Status:Normal; Type: C ;
FANU#6 Status:Normal;
Type: C ;
FANU#7 Status:Normal; Type: C ;
HDDBP Status:Normal; Type: A ;
XSCF>
10.6 Incorporating the SPARC M12-2S or
an I/O Device Into the PPAR
This section describes the following procedures:
■
Incorporating the SPARC M12-2S Into the Physical Partition Using PPAR DR
■
Incorporating an I/O Device Into the Physical Partition by Using the Hot Plug
Function
10.6.1 Incorporating the SPARC M12-2S Into the Physical
Partition Using PPAR DR
The operation described in this section is available only with the SPARC M12-2S.
1.
Log in to the XSCF shell.
2.
Incorporate the SPARC M12-2S into the physical partition.
The following execution example incorporates the SPARC M12-2S of BB#00 into
PPAR-ID#0 by using the addboard command.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023354