Fujitsu Oracle SPARC M12-2 User Manual

Table 5-14
Inactive/Cold Addition Procedure of the HDD/SSD (continued)
Work
Order
Task Reference
5Removing the filler unit from the SPARC
M12-2S
"15.3.2 Removing a Filler Unit"
6 Installing an HDD/SSD in the SPARC
M12-2S
"15.4.1 Installing an HDD/SSD"
7 Installing the power cords on the SPARC
M12-2S with the added HDD/SSD, and
incorporating it into the building block
configuration
"10.1.1 Installing a Power Cord"
"10.4.1
Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
8 Diagnosing the SPARC M12-2S with the
added HDD/SSD
"10.5.1 Diagnosing the SPARC M12
Hardware"
9 Confirming that there is no problem with
the added HDD/SSD
"10.5.3 Checking the FRU Status After
Maintenance"
10 Switching the mode switch on the OPNL
to Locked
"2.3.2 OPNL
Control Function"
11 Powering on the physical partition of the
added HDD/SSD
"10.9.1 Starting the System With an
XSCF Command"
12 Assigning the I/O resource to a logical
domain
"3.2 Operations and Commands Related
to Logical Domain Configurations" in the
Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 Domain Configuration
Guide
5.4.3 Inactive/Cold Addition Workflow of the CMUU
You can perform inactive/cold addition of the CMUU in the following configuration:
■
Building block configuration where two or more physical partitions are operating
Before adding the CMUU, see "Precautions for CMUU expansion" in "7.2
Precautions for FRU Expansion."
Table 5-15 shows the workflow for inactive/cold addition of the CMUU.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023170

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English