Fujitsu Oracle SPARC M12-2

Table 4-52
System-Stopped/Cold Replacement Procedure of the XSCFU
Work
Order
Task Reference
1 Checking the operating condition of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
2 Confirming the XSCFU to be replaced "8.2 Troubleshooting"
3 Confirming that the XSCFU to be
replaced is the standby or slave XSCF and
is currently replaceable (*1)
"Table 2-16 XSCFU LEDs and Their
States"
4 Stopping all physical partitions "9.5.2 Stopping All Physical Partitions"
5 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
6Removing the power cords of all the
SPARC M12-2/M12-2S units
"9.8.2 Removing the Power Cords"
7Removing the XSCFU from the SPARC
M12-2/M12-2S
"11.4 Removing the XSCFU"
8 Switching the SD
card (*2) "11.5 Switching an SD Card"
9 Installing the XSCFU in the SPARC
M12-2/M12-2S
"11.6 Installing the XSCFU"
■
HDD/SSD
■
HDDBPU
■
OPNL
■
CMU
■
Memory
■
BPU
■
PSUBP
■
Crossbar cable
■
XBU
■
XSCF DUAL control cable
■
XSCF BB control cable
■
PCI expansion unit
4.6.1 System-Stopped/Cold Replacement Workflow of
the XSCFU
Before replacing the XSCFU, see "Precautions for XSCFU and PSUBP replacement" in
"7.1 Precautions for FRU Replacement."
Table 4-52 shows the workflow for system-stopped/cold replacement of the XSCFU.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023132